Week 3, Lab 2 (Washboard Modelling)

"Set subdivisions Width = 17" 

selecting interior edges on the top of the box

after beveling

Extruding, n pulling the manipulator up

Beveling

creating the "top header" 

After aligning 'top panel' and 'top header'

aligning 'top stringer'

aligning 'glass' and 'top stringer'

'top stringer' duplicated and aligned 

'left leg' created

left leg aligned

                                       

left leg duplicated and aligned

left leg duplicated and aligned 

After beveling the edges

completed

REFLECTION...
i found this exercise fairly easy to do. The instructions were clear. However i felt that there could have been more screenshots included in the pdf document so that i can check if i was going in the right track.
the only problem i had was with the alignment as i found it slightly complicated.